How solder EC5 battery connector terminal using hotair ?

In my opinion it’s better to use hotair because You won’t touch ec5 body so You won’t left any solder left on sides – if You left then You will have trouble fitting conductor element into plastic case and need to use lot of force!!

 

  1. Strip wire
  2. Apply little bit of flux then add solder onto wire
  3. using hotair heat ec5 pin and fillĀ solder into hole (about half of hole)
  4. fit wire while heating, wait couple of seconds then remove heat source
  5. cold down and apply heat shrink tube
  6. fit pin into plastic case using flat screwdriver
  7. BEFORE STRIPPING ANOTHER WIRE MAKE SURE FIRST ONE IS FITTED INSIDE PLASTIC (or insulated) TO PREVENT ACCIDENTAL SHORT!!

Here pictures of that operation:

Leave a Reply

Your email address will not be published. Required fields are marked *


Warning: Undefined array key 0 in /www/wwwroot/electronicnoobblog.com/wp-content/plugins/wp-google-analytics-scripts/wp-google-analytics-scripts.php on line 602